Bodice Front Style 13 (BF2D-04)

style-13

The bodice of this garment has two darts; one in the mid shoulder and one in the waist. 

Using our two-dart block, we will pivot the side seam into the mid-shoulder and leave the waist dart as is.

Example: Outcome

Figure 1 shows the block being used on the left (2-Dart Block), and the pattern that will be created (Style 13) on the right.

Note: The actual pattern would need seam allowance or cutting instructions added; this has not been done here we are just covering the theory of manipulating darts.

style-13-outcome

Instructions (Style-13) - Figure 1

In the instructions, color is used for emphasis, so you can see more easily what I am referring to.  You will be using a hard (4H-6H) pencil.

  • Draw the new design line on your block; from the mid-shoulder to the Bust Point (not the Dart Point!).

I have marked the points A, B, C & D on the block to assist in the instructions.  You do not have to write these on your block.  Note that A, B, C & D relate to the points where the dart leg meets the edge of the block, as shown by the arrow tips.

style-13-instructions-01

Instructions (Style-13) - Figure 2

  • Holding the block firmly in place so that it doesn't move, trace around the block in a clockwise direction from point A (the new dart line) to point E (the first waist dart leg you will reach).

style-13-instructions-02

Instructions (Style-13) - Figure 3

  • Mark the Bust Point and the Waist Dart Point on the paper underneath the block by putting your pencil tip through the BP hole and the Waist Dart hole.
  • Extend the dart leg line (E) past the edge of the block. To make sure the line true, use a ruler to line up the Bust Point and the dart leg on the edge of the block, and continue that line beyond the block onto the paper (shown by a red arrow in the image).

style-13-instructions-03

Instructions (Style-13) - Figure 4

  • Holding the block down at the Bust Point, pivot the block anti-clockwise until the side seam dart is closed. (i.e. Dart leg D reaches the line you drew in the last step - shown by a red arrow in the image).

style-13-instructions-04

Instructions (Style-13) - Figure 5

  • Making sure the block doesn't move, finish tracing the remainder of the block from D to A.

style-13-instructions-05

Instructions (Style-13) - Figure 6

You can lift up the block now and put it aside. We will now see what we have on the paper underneath.

  • Draw the new dart legs from the Bust Point to points A1 and A2.  (They should be the same length, but check to make sure).
  • Finish off the dart, remembering that the Dart Point stops some distance before the Bust Point.

style-13-instructions-06

Instructions (Style-13) - Figure 7

  • Of course, if this was a pattern, you would need to label the pattern piece,  add seam allowance, cutting instructions, grainline, note the pattern piece number and the total  number of pattern pieces, etc.

style-13-instructions-07


  1. Comments (0)

  2. Add yours
There are no comments posted here yet

Leave your comments

  1. Posting comment as a guest. Sign up or login to your account.
Attachments (0 / 3)
Share Your Location